Publicité
Les langues disponibles
Les langues disponibles
English
If the bull point or cold chisel is used at the position
of "rotation + hammering", the tool can start to
rotate, resulting in unexpected accidents. Make
sure that they are used at the positon of
"hammering".
(1) Switching to "hammering"
(a) Turn the selector lever counterclockwise.
(b) Align L of the selector lever and
crank cover as illustrated in Fig. 8.
NOTE:
Turn the selector lever to check if it is completely
locked and make sure that it does not turn.
(2) When fixing working positions of tools such as cold
chisel, etc.,
(a) Turn the selector lever.
Align L of the selector lever and
crank cover as illustrated in Fig. 9.
Selector lever
10
Selector lever
Fig. 8
Fig. 9
(b) Turn the grip as illustrated in Fig. 10 and fix
the tool to the desired working direction.
of the
(c) Switch the selector lever to "hammering"
according to the procedures mentioned in the
above item (1) and secure the position of the
tool.
5.
Install the stopper (Fig. 11)
(1) Loosen the wing bolt, and insert the stopper into
the mounting hole on the side handle.
(2) Adjust the stopper position according to the depth
of the hole and tighten the wing bolt securely.
of the
6.
Warming up (Fig. 12)
The grease lubrication system in this unit may
require warming up in cold regions.
Position the end of the bit so makes contact with
the concrete, turn on the switch and perform the
warming up operation. Make sure that a hitting
sound is produced and then use the unit.
Grip
Fig. 10
Mounting hole
Stopper
Wing bolt
Fig. 11
Fig. 12
Publicité
