RealFlame 9750NG Manuel Du Propriétaire page 11

Using the Igniter
1. Read and understand all operating instructions before lighting.
2. Before beginning, make sure the control knob is in the "OFF" position.
3.
Connect the quick connect hose to the gas supply.
4.
Slowly turn the gas on.
5.
DO NOT lean over any part of the burner. Verify that the area
around theburner is free of hazards.
6.
Push in and turn the control knob counterclockwise to
the "LIGHT" position.
7.
Keep the control knob pushed in for 15-30 seconds after ignition.
WARNING: If ignition does not occur in 15 seconds, turn the control knob to the "OFF"
the fireplace and wait at least 5 minutes until the gas has cleared to repeat the lighting
procedure. Failure to do so could result in a large flashback of pooled gas, causing property
damage, serious injury, or death.
8. After successfully lighting the fireplace, release the control knob and turn it to the "LOW" setting.
Observe the flame and make sure that all the burner ports are lit.
9. Adjust the flame to the desired height using the control knob.
1. Turn the control knob to the "OFF" position.
2.
LIGHTING INSTRUCTIONS
Control Knob
Flame Height
11
8-14"
(20.3-35.5 cm)