Blaupunkt 5IX92290 Prescriptions De Montage Et Mode D'emploi page 61

Les langues disponibles

This device allows you to choose the operating mode (suction or filtration), depending on the

installation.

Upon first start-up, the display shows which operating mode is enabled.

Filtration: the display shows the letters C and the filter reset button flashes quickly.

Suction: the display indicates the letter C and the filter reset button is off.

During this phase you can change the operating modes by pressing the key F

A beep confirms the program change.

Once the set time elapses, the program will exit this operating mode and goes to standby mode or

by pressing the on/off button of the motor

To access the operating mode selection again, turn off power to the appliance and then power it

again.

Note: in suction mode, when the device is turned off, suction still operates for 20 minutes at a

minimum speed, to allow evaporating any possible condensation that has formed during the

cooking phases.

B:Motor on/off key: when touched, this key enables the motors; if pressed, it shuts down the

motor. By operating the keys "+" and "-" the user can modify the suction speed (power). In suction

mode, the 5th and the 6th are timed. For the version with 4-speed (serial) motor, only the 4th

speed is timed.

C:Suction speed (power) decrease key: when touched, this key decreases the suction speed of

the hood.

D:Suction speed (power) increase key: when touched, this key increases the suction speed of

the hood.

G:Filter reset key: when touched, this key will reset the warnings on anti-grease metal filter .

After 30 hours of hood operation, the symbol F, alternating with the symbol G, will flash indicating

the need to clean the anti-grease metal filters; this alarm prevents the operation of the suction

system until it is reset, to allow the condensate tray to empty (operation to be performed as

needed, but however each time you reset the filters).

FUNZIONAMENTO

OPERATION

Display