Publicité
Les langues disponibles
Les langues disponibles
Connecting and disconnecting the gas bottle
Parts and tools needed
excluded
The hose shall be approved according to EN16436-1:2014 with
sufficient length, allowing installation without any kinks (Length
shall not exceed 1.5m). The hose shall be readily visible across
its entire length for inspection after installation.
Gas regulator should be approved according to EN 16129:2013
with proper capacity (g/h), pressure, working temperature and
inlet + outlet connection for the country of destination.
DANGER! IGNITION OF ESCAPING GAS
Possible consequences:
Safety measures:
Operational Elements:
lever/
9 o,clock setting or rotate clockwise to the end:
Cylinder valve
12 o,clock setting or rotate anti-clockwise to the end:
than
LIGHTING INSTRUCTIONS:
1. READ OPERATIING INSTRUCTIONS BEFORE LIGHTING.
2. OPEN LID.
3. ENSURE KNOBS ARE IN "●" POSITION.
4. CONNECT REGULATOR WITH CYLINDER,THEN TURN ON.
5. PUSH AND TURN CONTROL KNOB ANTI-CLOCKWISE TO
APPROX 1/4 POSITION UNTIL A CLICK IS HEARD AND
BURNERS LIT.
6. ADJUST THE FLAME BETWEEN 1/4 TO 1/2 AREAS.
! WARNING
OUTDOOR USE ONLY. IF IGNITION DOSE NOT OCCUR WITHIN
5 SECONDS, TURN CONTROL KNOB(S) TO "●". WAIT 5 MINUTES
TO ALLOW GAS TO DISSIPATE AND REPEAT LIGHTING PROCEDURE.
ACCESSIBLE PARTS MAY BE VERY HOT, KEEP YOUNG CHILDREN AWAY.
DISCONNECT REGULATOR FROM CYLINDER WHEN THIS APPLIANCE
NOT USE IN A LONG TIME.
WARNING:
LID MUST BE OPEN WHEN BURNER IS ON OR HOT.
MAXIMUM WEIGHT ON SIDE SHELF: 6.8 KG / 15 LB
Function
rotate to the end
cylinder
Note
A-1
G5
9
G1
G2
12
G3
G4
1/4 position
1/4 to 1/2.
G1
G2
9
G4
G2
G4
setting or anti-clockwise
opened
B-1
G2
G4
Publicité
