MSI H410M PRO Mode D'emploi page 10

DIMM Slots
Please install the memory module into the DIMM slot as shown below.
1
⚠
Important
Always insert memory modules in the DIMMA1 slot first.
∙
∙
To ensure system stability for Dual channel mode, memory modules must be of the
same type, number and density.
∙
Some memory modules may operate at a lower frequency than the marked value
when overclocking due to the memory frequency operates dependent on its Serial
Presence Detect (SPD). Go to BIOS and find the DRAM Frequency to set the memory
frequency if you want to operate the memory at the marked or at a higher frequency.
∙ It is recommended to use a more efficient memory cooling system for full DIMMs
installation or overclocking.
∙
The stability and compatibility of installed memory module depend on installed
CPU and devices when overclocking.
∙
Please refer www.msi.com for more information on compatible memory.
M2_1~2: M.2 Slots
Please install the M.2 device into the M.2 slot as shown below.
3
Supplied
M.2 screw
1
Standoff
Overview of Components
10
1
3
2
30º 30º
2
2
3