Master -MITE HEAT GUN 10008 Mode D'emploi page 4

Repair and Maintenance Instructions
All repairs and maintenance
other than that recommended in
this instruction manual must be
performed by a qualified repair
technician who is experienced
with the repair of electric tools, a
qualified service organization, or
Master Appliance Corp.'s Service
Department.
Please contact Master's Customer
Service Department for genuine
Master Appliance replacement
parts or for repair service.
Operating Instructions
Before performing an application,
we recommend that you experi-
ment with a piece of scrap material.
Use care in approaching the work
surface until you find the proper
distance from the work area and
the proper heat application time.
Use a gentle back and forth
motion when applying heat unless
it is found that a concentrated heat
is desired.
To Operate Heat Gun
1. Plug heat gun into properly
rated outlet.
4
Repair Service Dept.
877-250-1934
sales@masterappliance.com
www.masterappliance.com
WARNING: Always unplug
your tool before performing any
maintenance or repairs. Use only
identical Master Appliance brand
replacement parts.
2. Move rocker switch to "Hot"
position. Heat gun will come up
to full operating temperature in
approximately two minutes.
3. When performing applications
where hands-free use is de-
sired, use bench stand.
4. To turn heat gun off after use,
move switch to "Cool" position.
Run on cool for approximately
three minutes. This will allow
the heat gun to cool down and
the nozzle and attachments to
become cool to the touch.
Cleaning
Unplug heat gun before cleaning.
To clean outside of tool, use only
a mild soap and damp cloth. Do
not use other cleaning agents,
turpentine, gasoline, lacquer or
paint thinner, or other solvents that
may contain chemicals which are
harmful to plastics and other in-
sulating materials. Never immerse
tool in a liquid or allow a liquid to
enter inside the tool. Make sure all
vents and openings are free and
clear of debris.
5. Move switch to "Off" position.
When heat gun is used in an
enclosed container, such as a
shrink tunnel or special enclo-
sure, ambient air must be
allowed to pass into the heat
gun and there must be an out-
let of equal size for the heated
air to pass out of the enclosure
also. Total enclosure will cause
damage or possible failure to
the heat gun due to the
extreme heat generated.
www.masterappliance.com