Alarm & Warning Pictographs - HONDA marine NMEA 2000 Mode D'emploi

Alarm & Warning Pictographs
There are four (4) system warnings & alarms which can be de-
tected by both gauges. These are displayed on the LCD display
as pictographs. These pictographs are set "ON" in the Tachom-
eter and "OFF" in the Speedometer from the factory, but can be
changed if desired to display simultaneously on both gauges.
Each pictograph is displayed one at a time in the order in which
the associated warning or alarm is detected. Each shall blink
until acknowledged by pressing the Enter key. After all alarms
and warnings are acknowledged, the previous display will be
restored.
As long as the alarm or warning is active, it will be displayed in
the alarms screen (see the alarm screen depicted below).
Charging fault
Engine over heating
ENG DATA
3125
Eng
Speed
Illuminated red as long as any
system faults remain active.
6
PGM-FI fault
Low oil pressure
ECO
rpm
PGN Data
Check engine
(PGM-FI)
Over heat
127489
Low oil pressure
Charge indicator
Water in fuel
Emergency stop
65280 ECOmo Mode indicator
A buzzer positioned in the Honda ignition switch panel will make
the boat operator aware of operational changes by providing an
audible alert and simultaneously illuminating the gauge Red LED
in the event of an alarm situation
Indicators
Type
LED
Icon
Color
Alarm Red
Alarm Red
Alarm Red
Alarm Red
Warning No Icon None
Warning No Icon None
No Icon Green
Audible
Alert
Yes
Yes
Yes
Yes
Yes
No
No