Rockford Fosgate PRIME R300-4 Installation Et Fonctionnement page 10

S
PECIFICATIONS
MODEL- PRIME
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Per Channel
2 Load Per Channel
4 Load Bridged
Dimensions: Height
Width
Length
Amplifier Fuse Rating (Amp)
Battery Fuse Rating (Amp) External (Not Supplied)
"A" Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range
Protection
Punch Level
Input Impedance
Operating Voltage
Balanced Inputs
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion + Noise)
These specifications are Amplifier Power Standard CEA-2006 Compliant
10
Specifications subject to change without notice
50 Watts x 4
75 Watts x 4
150 Watts x 2
2.40" (6.10cm)
7.67" (19.49cm)
17.09" (43.40cm)
(2) 25A ATC
12dB/octave Butterworth
High Pass @ 80Hz, Low Pass variable from 50Hz to 250Hz
20Hz to 20KHz ±1dB
Variable from 150mV to 8V (RCA Input)
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Selectable between 0dB, +6dB and +12dB @ 45Hz
20K ohms
9 to 16 Volts DC
>40dB @ 1KHz
< 1.0% @ 4 ohm
R300-4
50A
≥70 dB
≥90 dB
No
>200