Peavey CS2000H Mode D'emploi page 42

Rated Power:
Bridged 4 ohms:
2000W @ 1kHz @ <0.1% THD
2 x 2 ohms:
1000W per channel @ 1kHz @ <0.1%
THD both channels driven
2 x 4 ohms:
700W per channel @ 1kHz @ <0.05%
THD both channels driven
2 x 8 Ohms:
425W per channel @ 1kHz @ <0.05%
THD both channels driven
1 x 2 Ohms:
1325W per channel @ 1kHz @ <0.1%
THD
1 x 4 Ohms:
825W per channel @ 1kHz @ <0.05%
THD
1 x 8 Ohms:
500W per channel @ 1kHz @ <0.05%
THD
Minimum Load Impedance:
2 Ohms
Maximum RMS Voltage
Swing:
71 V
Frequency Response:
10 Hz–100 kHz; +0‚ -0.5 dB @ 1W
Power Bandwidth:
10 Hz–35 kHz; +0‚ -3 dB @ rated
4 Ohm power
THD (2 x 2 ohms):
<0.2% @ 700W per channel from
20 Hz–20 kHz
THD (2 x 4 ohms):
<0.1% @ 600W per channel from
20 Hz–20 kHz
THD (2 x 8 ohms):
<0.1% @ 400W per channel from
20 Hz–20 kHz
Input CMRR:
-85 dB @ 1 kHz
All manuals and user guides at all-guides.com
C S 2000H
® ®
S S P P E E C C I I F F I I C C A A T T I I O O N N S S
Voltage Gain:
x40 (32 dB)
Crosstalk:
> -70 dB @ 1 kHz @ rated power
@ 8 Ohms
Crossover:
Third Order State Variable Filters:
18 dB/octave
Frequency Range: 40 Hz–300 Hz
Hum & Noise:
> -108 dB; "A" weighted reference to
rated power @ 8 Ohms
Slew Rate:
> 15V/us
Damping Factor (8 Ohms):
> 500:1 @ 20 Hz–1 kHz
Phase Response:
+5 to -12 degrees from 20 Hz–20 kHz
Input Sensitivity:
1.32V +/- 3% for 1 kHz @ 4 ohm
rated power;
1.12V +/- 3% for 1 kHz @
2 Ohm rated power
Input Impedance:
15 k Ohms‚ balanced
Max Input Power w/typical
music program:
950W @ 2 Ohms
660W @ 4 Ohms
Max Input Power w/severe
music program:
2400W @ 2 Ohms
1650W @ 4 Ohms
Cooling:
Two front panel temperature-
dependent variable speed 80mm high-
output DC fans
42
Controls:
2 front panel attenuators‚ rear panel
Mode switch‚ Function switch per
channel‚ High Pass adjustable filter
per channel. High Pass filter bypass
switch per channel‚ adjustable
subwoofer crossover per channel.
Indicator LEDs:
2 ACL (clip limiting)‚ 2 Signal
presence‚ 2 Active status‚ 2 DC
protect‚ 2 Temperature limit
Protection:
Thermal‚ DC‚ turn-on bursts‚ subsonic‚
incorrect loads
Connectors:
Combi XLR & 6.3mm phone input;
Speakon and Binding Post speaker
output; 6.3mm High Pass or Full
Range patch connector per channel;
6.3mm Low Pass patch connector per
channel; 15 amp IEC mains connector
Construction:
16 ga. steel with cast aluminum front
panel and cast handles
Dimensions:
88.9mm x 483mm x 441mm (3.5" x
19" x 17.375" over all. 406 mm (16")
inside rack depth
Net Weight:
19.5 kg (43 lbs)
Gross Weight:
20.6 kg (45.5 lbs)
All power measurements made at 120
VAC‚ power transformer cold. 2 ohm
power is time limited by magnetic circuit
breaker.