Publicité
(Recoil)
Turn the
switch knob
a. Ignition circuit is switched on.
b. Fuel is switched on.
c. chock is switched off
6.1 Starting the engine
TIP:
The choke is not required to start a
1. Turn the ESC switch to "OFF" (1).
knob in to the position "ON".
(Electric)
Turn the switch to "CHOKE" .
a. Ignition circuit is switched on.
b. Fuel is switched on.
c. Chock is switched off.
2. Turn the air vent knob to "ON" (2).
Press the electric start switch
d.
as shown in the figure.
3. Turn the 3 in 1 switch to
a. Ignition circuit is switched on.
b. Fuel is switched on.
TIP:
The choke is not required to start a
c. Choke is switched on
knob in to the position "ON".
TIP: The choke is not required to start a warm engine. Push the choke
in the figure.
knob in to the position
4. Pull slowly on the recoil starter until it is
4. Pull slowly on the recoil starter until
engaged, then pull it briskly.
it is engaged, then pull it briskly.
TIP: Grasp the carrying handle firmly to prevent
the generator from falling over when pulling the
recoil starter.
TIP: Grasp the carrying handle firmly to prevent the generator from falling
over when pulling the recoil starter.
5. After the engine starts, warm up the
engine until the engine does not stop
when the choke knob is returned to the
"ON" position (4).
TIP: When starting the engine, with the ESC "ON", and there is no load
on the generator:
• In ambient temperature below 0°C (32°F), the engine will run at the
rated r/min (4500r/min) for 5 minutes to warm up the engine.
• In ambient temperature below 5°C (41°F), the engine will run at the
rated r/min (4500r/min) for 3 minutes to warm up the engine.
• The ESC unit operates normally after the above time period, while the
ESC is "ON".
to "CHOKE" .
OPERATION
Recoil
Electric
"CHOKE" (3),
Press the electric start switch as shown
"ON".
- 19 -
warm engine. Push the choke
warm engine. Push the choke
Press towards
the left
Handle
19
Publicité
