AEG AXP26U338BW Manuel D'utilisation page 18

18 www.aeg.com
after an additional 30 minutes. This new
temperature will be maintained for 7 hours
before it returns to the originally selected
temperature. This ends the "Sleep" mode
and the unit will shut down automatically.
The "Sleep" mode program can be
cancelled at any time during operation
by pressing the "Sleep", "mode" or "fan
speed" button.
Note: In Fan or Dry mode, Sleep mode
cannot be set.
Louver Swing Function
Press the "swing" button to enable louver
swing function, and the upper side of
screen will display "
on the top panel will swing up and down.
Press this button again to disable the
louver swing function.
°F/°C function
Press the " " and " " button the same
time for more than 3 seconds to switch
between degree Fahrenheit and degrees
Celsius. Under Dry/Fan mode, you can
not select °F/°C.
Timer mode
How to delay startup
Plug in the unit, so the unit turns to
standby. Press the "timer" button, the
screen will display "timer"and "h", and
the "on" will flashing.
Tap or hold the UP arrow " " or the
DOWN arrow " " to change delay start
timer at 0.5 hour increments up to
10 hours, then at 1 hour increments up
to 24 hours. After 3 seconds, the setting
will be memorized. The control will count
down the time remaining until startup.
You can also press the "timer" button
again directly and the "on" will stop
flashing immediately, then the unit will
start up in the mode as previously set.
You can set up the mode and the unit will
start up as you preferred after "on" stop
flashing.
To cancel the setting, press the "timer"
". The louver
button again.
How to delay shutdown
You can delay shutdown when the unit is
on. Press the "timer" button, the screen
will display "timer"and "h", and the "off"
will flashing.
Tap or hold the UP arrow " " or the
DOWN arrow " " to change delay stop
timer at 0.5 hour increments up to
10 hours, then at 1 hour increments up to
24 hours. After 3 seconds, the setting will
be memorized, and the display will show
the time remaining until the unit shuts
down.You can also press the "timer"
button again directly and the "off" will
stop flashing immediately.