AEG AXP26U338BW Manuel D'utilisation page 16

16 www.aeg.com
Filter reset
This feature is a reminder to clean the Air
Filter (See Care and Cleaning) for more
efficient operation.
The filter indicator will illuminate after
250 hours of operation. To reset after
cleaning the filter, press the "filter reset"
button, then the "filter" indicator will go off.
7.2 Remote Control
1 Remote Control screen
2 Temp/Timer setting button
3
Mode button
4 Timer button
5
On/Off button
6
Speed button
7 Sleep button
8 Swing button
Battery Installation and Important
Instructions
Remove the cover at the back of the
remote control.
Insert the provided batteries correctly
(see the instructions inside the battery
compartment).
Close up the cover.
To replace the old batteries (which have
been used up) with two new R03P "AAA"
1.5V batteries, repeat the steps above.
If the remote control unit is replaced or
discarded, the batteries must be removed
and disposed of in accordance with
local legislation as they do harm to the
environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium)
batteries.
Do not dispose of batteries in fire. Batteries
may explode or leak. If the remote control
is not used for a long time, remove the
batteries from the remote control.
The remote control must be handled with
extreme care. Do not drop it or expose it
to direct sunlight or sources of heat.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Point the remote control at the location
of the signal receiver. The remote control
must be no more than 16 ft (5 meters)
away from the unit (without obstacles
between the remote control and the unit).