AEG AXP26U338BW Manuel D'utilisation page 17

How to Use the Remote Control
TURNING THE UNIT ON
Plug in the unit, then press the "on/off"
button (when turned on, the unit will
operate as the last setting before
shutdown.
To switch the unit off, press "on/off"
button again, then remove the plug.
Always switch the unit off by pressing the
"on/off" button and wait for few minutes
before removing the plug.
Cool mode
Press the "mode" button until the left side
of LCD screen displays "cool".
Press the "fan speed" button to choose
the fan speed "auto", "high", "mid", and "low".
Press the " " and " " button to choose
the temperature you want.
Dry mode
Press the "mode" button until the left side
of LCD screen displays "dry".
At the same time, the "low" fan symbol
appears on the screen.
Note: In this mode, fan speed cannot
be selected.
Fan mode
Press the "mode" button until the left side
of LCD screen displays "fan".
In this mode, you can select fan speed
"high", "mid" or "low" by pressing the
Fan speed button and referring to the
diagram.
Note: In this mode, the air exhaust hose
does not need to be connected.
Heat mode (For Heat & Cool models only)
Press the "mode" button until the left side
of LCD screen displays "heat".
Press the "fan speed" button to choose
the fan speed "auto", "high", "mid", and "low".
Press the " " and " " button to choose
the temperature you want.
AUTO mode
Press the "mode" button until the upper
side of LCD screen displays "auto".
Under AUTO mode, you can not select
the fan speed.
Press the " " and " " button to choose
the temperature you want.
Sleep mode
When the unit is in Cool, Heat or auto
mode, you can press the "sleep" button
to make the unit run in Sleep mode. In
this mode, the fan speed will be set as
"auto" automatically, which cannot be
changed.
In Cool/Heat mode the selected
temperature will increase/decrease
by 1°C 30 minutes after the mode is
selected. The temperature will then
increase/decrease by another 1°C
ENGLISH 17