Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION OF THE TOOL
1. BASIC CHARACTERISTICS
Lenght:
272 mm
Height:
275 mm
Width (over the angle valve) :
Weight:
1,65 kg
Stroke:
21 mm
Stroke force at 0.6 MPa:
Air consumption:
2 L / stroke
Working pressure:
5 to 7 bars
Front nozzle diameter:
22.5 mm
Front nozzle length:
64 mm
Capacity:
Ø RIVET
4,0
4,8
5,0
ALUMINIUM
STEEL
STAINLESS
STEEL
Intensive use
Occasional use or small series
2. TOOL OPERATION
Description of the tool:
1 - Nose-piece
2 - Mandrel tube
3 - Trigger
4 - Revolvable air supply
5 - Mandrel container
6 - Ring relief
7 - Unscrewing button
The manufacturer equipped the tool with an nose-piece /fig. 1 - pos.1/ for a rivet Ø4.8-5.0.
Riveting with blind rivets of different diameters (further on referred to as BR) requires use of
appropriate nose-pieces /figure 1 - pos. 1/ that are located in the accessories casing of the
tool.
Replacement of nose-pieces:
Connect the tool to the source of compressed air, depress the
trigger and screw out the nose-piece /figure 1 - pos. 1/ with a
spanner no. 12. Screw on a new nose-piece /ace.te the chart/
and tighten it.
Now you can release the trigger of the tool.
Recommended numbers of nose-pieces with respect to rivet
diameters (does not apply for all types of rivets).
The tool is equipped with revolving air supply /fig. 1 - pos.4/ which enables manipulation with air
supply before as well as during tool operation, air hose does not obstruct riveting in any position.
The tool is equipped with a trigger /fig.1 - pos.3/. Released trigger enables pushing a rivet into the
tool (the tool is ready for riveting), depressing the trigger shall fix the rivet.
120 mm
12,5 kN
6,0
6,4
FIG.1
Ø Rivet
Marking of nose-piece
4,8 - 5,0
nose-piece no. 5
4,0
nose-piece no. 4
6,0
nose-piece no. 6
6,4
nose-piece no. 6.4
E-640RA - User Manual
EN
FR
IT
• 3
Publicité
