Preparing The Remote Control; Inserting The Batteries - Akai STD-2000 Manuel D'utilisation

Preparing the remote control

Inserting the batteries

1 1. Open the cover
2
2. Insert the batteries (2 x AAA
size - 1.5 V batteries)
Make sure that the + and – poles of the
batt eries coincide with the marks on the
of the battery compartment.
inside
3
3. Close the cover
Notes:
The incorrect use of batterie
leakage of the inner liquid and corrosion.
handle the remote control safel
To
follow these instructions:
●
Do not put the batteries in the wrong way.
●
Do not recharge, heat, open or
circuit the batteries.
●
Do not throw the batteries in the fire.
●
Do not leave empty batteries
remote control.
●
Do not use different types of battery at
the same time. Do not mix new batteries
old ones.
with
●
If you are not going to use the remote
cont rol for a long period of time, remove the
batteries to avoid potential corrosion damage.
●
If the remote control does not work
correctly, replace with new batteries.
working dist ance is very short,
●
If liquid leakage occurs in
carefully clean the battery compartment
and then put new ones in.
Using the remote control
Point the remote control towards the DVD
player's sensor. (The images below are only
for reference).
Note: Do not expose the remote control or
th e DVD player to strong li
direct
Notes:
s can produce
●
Point the remote control directly towards the
DVD player.
y,
●
Do not leave the remote control in
hot or damp place.
●
Do not spill water or place anything wet on
the remote control.
short- ●
Battery life is of approximately
normal use conditions.
inside the
or the
side the batteries,
78
PLAY/PAUSE
NEXT
STD-2000
PREV
POWER
FUNCTION
OPEN/CLOSE
DISPLAY POWER
TIME
+
PROGRAM CLEAR SUBTITLE TITLE
SETUP RETURN
ENTER
REPEAT V-MODE
A-B PBC
MENU
USB/CARD REC
PLAY/PAUSE STOP L/R LANGUAGE
REV FWD PREV NEXT
HDMI SLOW VOL- VOL+
DVD/DVB MUTE ZOOM RADIO/TV
sunlight.
Other
ght such as
an excessively
one year in