Duratech PLP-REM-300 Mode D'emploi page 19

Troubleshooting
PROBLEM
The PLP-REM doesn't react to
transmitter commands
The pool lights don't work
or don't change colors
correclty
Handheld transmitter does not
function anymore after firmware
update of the PLP-REM-300 for
LinkTouch compatibility
SOLUTION
• Perform a RESET procedure
• Check the battery of the handheld
transmitter (see p.11)
• The transmitter is not paired-
correctly with
Repeat the pairing process
• Reduce the
handheld transmitter and PLP-REM
and/or remove obstacles
• Check the General status light on
the logic board. If it's red, then
the secondary voltage is too high
(>14VAC) or there is a short circuit
• Perform a RESET procedure
• Check if all connections are made
according to the electrical scheme.
• Switch the PLP-REM-300 to ON/
OFF mode (DIP switch nr 1) and
check if the lamps work
• Buy a new TX868 transmitter that
has updated firmware
the PLP-REM.
distance between
19