Duratech PLP-REM-300 Mode D'emploi page 11

Replacing transmitter Keypad
Depending on which control mode is selected, the keypad of the transmitter
needs to be changed:
• Remove the philips head screw and open the transmitter
• Replace the Keypad in the top part of the transmitter housing
• Reassemble in reverse order
Transmitter battery
Check battery status:
Push and release any button on the remote. The green LED should still light
up 0,5 second after you released. If the LED stops faster, then the battery
needs to be replaced
Replacing transmitter battery:
• Remove the philips head screw and open the transmitter
• Replace the battery, respecting the polarity
Battery type: A23 12V
Keypad for
PLC mode
Keypad for
ON/OFF mode
+
11