Qlima R7224S C-2 Manuel D'utilisation page 89

15
5/16"
17
STEP 16
19
STEP 18
21
STEP 20 STEP 20
23
STEP 23
25
15. Raise the wick to its highest position and tighten the
16
16. Check the wick height. It should be 5/16 above the collar.
17. Check for the correct clearance between wick holder
18a. Reinstall the tip-over switch assembly by pushing the
18 18b. Connect the 3 connectors (3EA) with the circuit board.
STEP 17
18c. Remove the connector (1EA) from the ignitor.
19. Check the function of the tip-over safety stop by push-
20. Reinstall the automatic ignition assembly.
21. Reinstall the wind cover A / B.
22. Reinstall the cabinet .
STEP 19
20
23. Tighten the 5 screws on the cabinet and reinstall the
24. Reinstall the combustion chamber 4 and the fuel tank
25. Reinstall the wick adjusting knob 2 and ignition
STEP 21
22
24
tighthen them.
wing nuts in several steps.
and draft tube. It should be the same all around.
extinguish knob .
ing the extinguish button  to upset the pendulum.
sensor at the back of the cabinet .
.
button 3. Close the front plate.
Install the batteries in the battery case and fill the fuel
tank with Qlima Premium Quality Fuels. Set the tank
into the heater and wait at least 180 minutes for the
new wick to fully saturate with the fuel.
4
77