Publicité
Les langues disponibles
Les langues disponibles
PILOT LIGHT & BURNER ADJUSTMENT
Note: The pilot light
on
the appliance
the flame.
1.
Turn
off the
gas
supply valve and
2.
Turn
all
burner
control valves to the
3. Hold
an ignition source (match)
4.
Open the gas supply
5.
Turn
the
burner
control valves
and
increase the size
ignition. The
pilot flame
when
the burner
Main Burner Adjustment
Note:
The pilot burners
provide
1.
To light
burner,
turn
2.
Adjust
flame height
3.
To turn off, turn
4.
To shut
down appliance, turn
Main Burner Air Supply Adjustment
Note:
For efficient
burner
result
in
complete combustion. Insufficient air supply
the
mixing
of
air
and gas.
1.
Loosen
the
air
shutter retaining screws on the
yellow tips
of
the burner
2.
Lock
the
air
shutter
eliminate
the
excessive mixing
Main Burner Air Supply Adjustment
The main burners should burn with a steady blue flame, and the inner
cone of the flame in each port should be about ¾" long.
Set the supply pressure to deliver the desired flame height& appearance
between 3.75 to 5" WC for Natural Gas and 9.5 to 11" WC for LP.
has
been
set at
wait 5 minutes to clear
"OFF"
at the pilot.
valve.
Once the pilot flame
to
"ON".
If
of
the pilot
flame.
If
the
should
be as small as
control valves
are turned
ignition for
the main
burner
control valve
to "ON."
to
desired position
by turning
burner
control
valve
to
"OFF".
off
manual gas supply
operation, a proper
balance
flame.
in place by tightening
air
intake.
the factory. A
screwdriver may
the
gas.
position.
is established,
remove
the pilot does
not
ignite the burners, promptly, turn
pilot
flame appears
larger
possible
but
large enough
to
"ON".
burners.
the
burner
control
valve.
of
gas volume
and
results
in a
yellow flame. An
front of the
burner and increase the
the
screws.
If flames are
noisy and
Page 10
be
required
for the first lighting to
the
ignition
source.
than
necessary,
turn
it down and
to
guarantee
reliable
valve.
primary air
supply
must be maintained which
air
shutter
on
the
front of
air
inlet opening size
pale blue, reduce the
Yellow Tips –
Blowing/Lifting
Too little air or
Flames –
too much gas
Too much air
adjust
off
burner
control
valve
retest
burner
ignition of the
burners
will
the
burner
controls
to
eliminate the
air openings to
Normal Flame
Publicité
