Publicité
M1.1.WEL30.NLFREN - 11062020
EN
7 Trouble shooting
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if
you can solve the problem before calling the service centre.
Problem
The heater does not operate, even
when it is plugged in and the switch,
thermostat are switched on
The heating element is glowing
The appliance does not heat up, or
only ventilator works
Abnormal noise
8 Disposal
Environmental protection
Waste electrical production should not be disposed of with household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
Possible causes
The plug is loose, bad connection
No power in socket outlet
The input voltage is too high or too
low
The air inlet grill is blocked
The switch is not put at heating setting
The thermostat operates
The self-resetting cut-out operated
The appliance is not stands upright
13
Solutions
Pull out the plug, check the connection of
the plug and socket. Then connect again
Insert the plug in a proper socket
Use power supply according to the rating
on the label
Keep the heater far way from articles like
curtain, plastic bag, paper and other
things which can cover the inlet or can be
easily cover on the air inlet
Turn the switch to heat setting
Turn the thermostat and listen if there
is open/close voice. If there is no click
and the thermostat is not damaged, the
heater will automatic switch on when the
appliance cooled down
Turn the heater off and inspect the
blockage of inlet or outlet. Disconnect
the plug and wait at least 10 minutes
for the protection system to reset before
attempting to restart the heater.
Put the heater on a level surface
Publicité
