Inventum IPF650R Manuel D'utilisation page 15

3. Remove the exhaust hose (B).
Caution:
Make sure that you cover the exhaust opening (A), if present.
Installing the filter
1. If necessary, put the adaptor (A) on the extractor hood.
Warning:
The adaptor is only necessary when the motor of the extractor hood is too close to
the wall.
2. Put the hose clamp (B) and the filter (A) on the extractor hood or the adaptor.
3. Tighten the hose clamp.
Connecting the filter
1. Connect the extractor hood plug and the filter plug to the mains supply or to the mains adaptor and then the
mains supply.
Finishing the installation
1. Install the shaft on the extractor hood.
2. Make sure that the shaft has sufficient openings for ventilation.
5 Operation
PREPARING FOR OPERATION
1. For optimal room air cleaning, it is imperative for your extractor hood to be adequately ventilated and adapted to
the respective steam development.
2. Make sure that you activate your extractor hood at level 1 or 2 at least 10 minutes before you start cooking.
COMPLETING OPERATION
1. Make sure that your extractor hood operates at level 1 or 2 for 15 minutes after you finish cooking.
6 Technical data
PRODUCT FICHE
Item
Capacity
Features
Pressure loss
Contact time / Inflow speed
Specification
3
650 m
Suitable for all extractor hoods (new / pre-installed)
Cleaning the air and removing bad odours up to 98%
Long lifespan
Self cleaning
No ozone O
3
Double filter: plasma and carbon
Compliant to RoHS directive
100 Pa per 2 m/s
depending on level of contamination
(Figure 3)
(Figure 4)
(Figure 5)
(Figure 6)
English • 15