Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
Location of rating plate
GB
GB
WARNING
If the information in this manual
is not followed exactly, a fire or
explosion
may
property damage, personal injury or
death.
Introduction
Please
read
COMPLETELY AND CAREFULLY. They
will save you time and effort and help to
ensure optimum oven performance.
Be sure to observe all WARNINGS.
These installations are intended for use
by a qualified installer.
In addition to these instructions, the
oven shall be installed:
•
In Canada, in accordance with
Canadian Electric Code C22.1-
latest
edition/Provincial
Municipal
codes.
These shall be carefully followed at all
times.
NOTE: IF INSTALLING YOUR OVEN
IN CANADA PLEASE CHECK TO
MAKE SURE THAT YOU HAVE
result
causing
these
instruction
codes
and/or
local
A MODEL WITH THE CANADIAN
LISTING.
MARK, AS SHOWN ABOVE:
Mark as shown above means the oven
complies with both US and CANADIAN
Standards.
Tools you will need
The following tools are needed to install
your new oven:
•
Tape measure and straight edge
or rules
•
Pencil
•
Phillips screwdriver
•
Level
•
Wire cutters and wire stripper
•
Hand or saber saw
•
1" (2,5 cm) Hole saw
•
Drill and drill bit
•
Safety gloves and goggles
•
Volt meter (0-250VAC)
Packaging
and
Remove all tape and packaging before
using the oven.
Destroy the packaging after unpacking
the oven following the rules in force in
your town. Never allow children to play
with packaging material.
Power requirements
The oven must be supplied with the
proper voltage and frequency. The oven
is manufactured to be connected to a
three-wire, single phase, 240 Volt, 60
14
14
14
Publicité
