Termozeta NO LIMITS SUPER COMPACT Mode D'emploi page 14

IRONING
• Press button (11) on the iron for the steam jet: the steam will stop coming out when
you release the button.
• To use the continuous steam function, press the steam button (11) and at the same
time slide cursor (11a) towards the cork handle. To disable this function, slide cursor
(11a) in the opposite direction to the handle.
• With the iron held upright at a distance of about 20 cm you can use the jet of steam to
smooth out creases and freshen up clothes while they are hanging. Avoid carrying
out this operation on any worn garment as the steam is extremely hot and it is
possible to get burned.
• Before ironing delicate fabrics it is best to make trial run on a hidden piece e.g.
the hem.
• We advise you to iron more delicate fabrics needing low temperatures first, then
go on ironing more resistant fabrics needing higher temperatures.
WARNING!
Some drops of water may leak out of the iron soleplate (10) when the first jet of steam
starts coming out; this is quite normal and is due to condensation forming inside the
iron-boiler connecting tube (6).
This will disappear with the following jets of steam. It is therefore not recommended to
point the first jet of steam directly on the item to be ironed. The iron must be used and
left at rest on a firm surface.
NO MORE WATER DURING USE
• When the water tank is empty the indicator lamp (8a ) will light on.
• Carefully follow the instructions given below to fill up the boiler again:
- Press the ON/OFF switch of the boiler (2) bringing it to the "OFF" position;
- unplug the appliance from the outlet;
- remove the cap (5);
- fill up the tank following instructions given in the "HOW TO FILL THE TANK WITH
WATER" paragraph;
- switch on the appliance again following the same instructions given in the "STARTING
UP" paragraph.
WHEN YOU HAVE FINISHED IRONING
• Press the ON/OFF switch of the boiler (2) bringing it to the "OFF" position.
• Press button (14) on the iron, until no more steam is being produced.
• Unplug the appliance from the outlet.
• Rest the iron on base (3) and wait for the appliance to completely cool down before
carrying out any operations.
ENGLISH