Publicité
If you are heading for a working area which lies outside the Bluetooth signal range,
Working Mode
you may activate scanner's store mode, following steps described below. Under this
mode, all scanned data will be stored directly into the buffer memory of the device.
Furthermore, data entries will be permanently saved in the buffer memory prior to
the manual upload into the working station, so that you may upload them when you
are near your working device.
*Normal Mode
Store Mode
Output Stored Data
Output Total Entry
Clear Memory
Note: On Store Mode scanner will make 2 beeps when memory is full .
Time period set for scanner from idle to sleep. Default Idle Time: 3mins.
Idle Time
$POWER#OFF
$RF#ST00
Power Off
0 Min
(4)
Publicité
