Publicité
Firmware version will be displayed by scanning "$SW#VER".
Firmware Version
$SW#VER
Scanning the following barcode can restore the scanner to factory defaults.
Factory Defaults
%#IFSN0$B
NetumScan barcode scanners are factory programmed for the most common terminal
Barcode Programming
and communication settings. If you need to change these settings, programming is
accomplished by scanning the bar codes in this guide. An asterisk (*) next to an
option indicates the default setting.
Get Started
Scanner transmits data to your device via USB Dongle or USB cable. You can choose
Connection Way
either way to start scanning.
(1) Plug the USB dongle into your device(Wireless Transmit was set by default).
How to transmit data via 2.4G USB Dongle?
(2) Power On the scanner.
(3) Setup keyboard language: US keyboard was set by default. If you use other type of
keyboard please refer to Keyboard language.
(1)
Publicité
