Publicité
Les langues disponibles
Les langues disponibles
3.4 Set Temperature
To set the temperature in the cooling zone press
the temperature controller +/-
The left cooling zone
the temperature control
The temperature is stored, if the temperature controller
is not used for more than 4 s. The display stops flashing.
To set the right cooling zone
temperature controller +/-
press the SET button
cooling zone. Now it can be adjusted with the temperature
controller +/-
The temperature is stored, if the temperature controller
is not used for more than 4 s. The display stops flashing.
3.5 Using the Device Without Power
Please ensure an uninterrupted power supply during operation.
The device is not designed for operation without power
supply and can only keep its temperature to a limited time,
depending on the outside temperature.
3.6 Using the Device in a Car (Battery Protection)
The device is equipped with a three-stage battery monitor.
To protect your battery, the unit switches off when the
respective battery voltage falls below (error F1).
•
Use the High mode if you have connected the device to
your starter battery
•
Use the Medium mode if you have connected the device
to your starter battery and the conditions are good (e.g. no
severe cold, no severe heat, no long periods of standing)
•
Use the Low mode only when using separate supply batte-
ries to ensure vehicle starting. If this mode is used when
connected to the starter battery, it may not be possible to
start the vehicle
34
L
flashes and can be adjusted with
14
14
12
to enter the setting of the right
14
.
14
R
, press a key on the
. Afterwards
14
14
Publicité
