Vonyx AM Serie Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROL ELEMENTS
1. BALANCE MICROPHONE INPUT
Balanced XLR input jacks.
2. LINE INPUT
Balanced 6.3mm (¼") jack line inputs. You can connect either balanced or unbalanced
phone plugs to these jacks.
3. GAIN
Adjusts the input signal level.
4. HI EQ
Adjust the high tone each channel.
5. LOW EQ
Adjust the low tone each channel.
6. EFFECT
Use this control to set the effect level you want to achieve. The EFF control adjusts the
input signal to give you a desired effect.
7. PAN
The PAN control determines the position of the channel signal within the stereo image.
When working with subgroups, you can use the PAN control to assign the signal to just
one output, which gives you additional flexibility in recording situations.
8. PFL
The PFL (Pre- Fader Listen) function allows the user to listen to the level before fader
control. Used for headphone monitoring of each channel, regardless of the main mix
9. PEAK
This is the lamp which indicates the input signal level of this appliance ( regardless of
output) when GAIN volume is adjusted.
10. CHANNEL FADER
Adjusts the level if the channel signal. Use these faders to adjust the balance between
the various channels.
3