Metabo SPA 1702 Notice D'utilisation page 14

ENGLISH
6.4 Filter, filter retaining clip and dust bag
Screw M6 hexagon nuts into the filter retaining
clip (2) halfway up the thread. Push on
washers 6,4 and insert filter retaining clip (2)
into the holes provided on the extractor (6).
Secure washer 6,4, stranded earth wire and
serrated lock washer to the filter retaining clip
(2) with M6 hexagon nuts, as shown in the
illustration. Tighten M6 hexagon nuts.
Screw on washer 6,4 with M6 hexagon nut on
the other side of the filter retaining clip (2) and
tighten.
Push the filter (1) over the filter retaining clip
(2). Push tension band over the filter (1). Push
the filter (1) with tension band over the
connector on the extractor assembly (6). Make
sure that the filter (1) is over the extractor
connector (6) all the way round and is
positioned under the tension band. Secure the
tension band with a screwdriver.
14
6
11
Push tension band (9) over the dust bag (11).
Push tension band with bag over the connector
on the underside of the extractor assembly (6).
Make sure that the dust bag (11) is over the
extractor connector (6) all the way round, and
is positioned under the tension band. Align
tension band so that it is positioned on the
foam strip all the way round. Secure the
tension band (9) by folding over the locking
lever.
6.5 Suction hose
Push the hose clamp (8) over the suction hose
(10). Push the suction hose (10) onto the small
connector on the extractor assembly (6). Make
sure that the suction hose (10) is positioned
correctly all the way round. Secure the suction
hose with the hose clamp (8).
9
9