Accessories - Braun 8 Série Mode D'emploi

Masquer les pouces Voir aussi pour 8 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Automatic cleaning
Start the cleaning process by pressing the start button (16). If status light (15b) does
not shine (C & C switches to stand-by after ca. 10 minutes), press start button twice.
Otherwise, cleaning will not start.
Depending on your model and / or program selected, the cleaning time takes up to
3 minutes. During this time the status light (15b) blinks.
After cleaning and charging is completed, all indicators turn off.
Leave the shaver in the C & C for drying. It takes several hours until remaining
moisture evaporates depending on the climatic conditions.
Removing the shaver from the C & C
Hold the C & C with one hand and tilt the shaver slightly to the front to release it.
Cleaning cartridge / replacement
When the level indicator (15a) lights up permanently red, the remaining fluid in the
cartridge is sufficient for about 3 more cycles. When the level indicator blinks red, the
cartridge needs to be replaced – about every 4 weeks when used daily.
After having pressed the lift button (13) to open the housing, wait for a few seconds
before removing the used cartridge to avoid any dripping. Before discarding the used
cartridge, make sure to close the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning solution.
The cleaning cartridge can be disposed of with regular household waste.
The hygienic cleaning cartridge contains ethanol or isopropanol (specification see
cartridge), which once opened will naturally evaporate slowly. Therefore, each cartridge,
if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge
also contains lubricants for the shaving system, which may leave residual marks on the
outer foil frame and the cleaning chamber of the C & C. These marks can be removed
easily by wiping gently with a damp cloth and do not impact the shaver and its
performance in any way.

Accessories

Braun recommends changing your shaver's Foil & Cutter cassette every 18 months to
maintain your shaver's maximum performance.
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 83M
• Cleaning Cartridge: CCR
• Braun Shaver cleaner spray
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

83 cc série83 s série8385cc5795

Table des Matières