Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product manufactured
by Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly
wired installation, we kindly recommend you to expend a few minutes of your time to read this manual.
INDEX
Introduction ...........................................29
Index.....................................................29
Starting recommendations .......................29
System characteristics ..............................30
System operation ....................................30
Door panel PES-1220 .................................
Description..........................................31
Location......................................32 to 33
Wiring.................................................33
JP2 configuration jumper.......................33
Final adjustements................................33
Push button label ..................................34
Close the door panel.............................34
Power supply FA-133 ...................................
Installation ..........................................35
Characteristics .....................................35
Lock release installation ...........................35
STARTING RECOMMENDATIONS
O Do not use excessive force when tightening the power supply connection block screws.
O Install the equipment without the power connected.
O Before connecting the system, check the connections between door panel, telephone/s and the
power supply connection.
O Only use compatible T-1772VD telephone.
O Only use parallel or twisted cable (to sections see page 40).
O Do not use single wire.
O Do not double the cable to increase the section.
O The entire installation must be at least 40 cm. away from any other installation otherwise there is
a risk that the audio signal be exposed to interference, or that the system does not work correctly.
O Always use 12 Vd.c. lock releases (cod. 20600149, not included in the kit).
O Do not switch voltage higher than 12 Vd.c. / 1A between C and NO door panel terminals.
O Do always follow the enclosed information.
T-1772VD telephone...................................
Description..........................................36
Function push buttons ...........................36
Connection
terminals............................36
Call volume control ..............................37
JP2 configuration jumper.......................37
Intercom function .................................37
Fix the telephone ..................................38
Installation diagram ....................................
Connection to (1 apartment) ..................39
Connection to (2 apartments).................39
Sections chart ......................................40
Connection a.c. lock release..................40
Connection auxiliary device ...................40
Troubleshooting hints ..............................41
Notes ....................................................42
29
Publicité
