Abicor Binzel eBOX Mode D'emploi page 43

eBOX
10 Troubleshooting
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and machine damage.
The product warranty will be rendered invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried out by qualified personnel
Please observe the attached document "Warranty". In the event of any doubts and/or problems, please
contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source,
Fault Cause
• Control system or component defective
Unit is not
ready for • Gas flow controller defective or set incorrectly
operation
• M-Drive safety switch not actuated
• Motor defective
Wire is not fed
• Defective control lead. No feed or only 100%
feed possible
LED does not • Fuse switched off
illuminate
Tab. 15 Troubleshooting
10.1 Reading the error memory
Please see the information on the SD card instruction leaflet BEI.0144.0 Tab. 2.
DANGER
(in Germany see TRBS 1203).
welding torch system, re-circulating cooling unit etc.
Troubleshooting
• Ask a Binzel specialist to replace the defective control
system or component
• Ask a Binzel specialist to check and set the gas flow
controller
• Ask a Binzel specialist to check the switch
• Switch off the power to the system
• Ask a Binzel specialist to replace the motor
• Press the reset button
• Replace the feed system
• Check the control lead and the connectors. Replace the
control lead if necessary
• Check that a power supply is available and/or if the light
on the power supply unit illuminates. If not, replace the fuse
10 Troubleshooting
EN - 21