LENCO LPJ-700BKGY Mode D'emploi page 17

5. Press the
Connecting a VGA source
Follow the picture below to connect a device with a VGA cable.
1. Turn off the projector before connecting the VGA cable.
2. Press the
connecting.
3. After connecting, press the
power indicator will up light GREEN
4. Press the
VGA device will show on projector screen.
5. Press the
Please refer to the following table to adjust the output signal from
computer.
Type Resolution
button to turn off the unit power.
button to turn off the power of your projector before
/SOURCE button to go to the VGA mode and the video of
button to turn off the unit power.
button to turn on the projector and the
Frequency
16
Field Frequency