LENCO LPJ-700BKGY Mode D'emploi page 16

power indicator will light up GREEN
3. Press the
HDMI device will show on the projector screen. There are 2 HDMI inputs,
HDMI1 interface corresponds to HDMI 1 in SOURCE mode, and HDMI2
interface corresponds to HDMI 2 in SOURCE mode.
4. Press the
HDMI HD signal input
- Using a MHL HDMI cable:
This projector is compatible with MHL cables: this means that you can
connect your smartphone or tablet (if MHL compatible) and stream in HD
from your smartphone or tablet to the projector with a MHL cable (not
included).
- Using a Chromecast dongle:
The HDMI connectors are compatible with the use of a chrome cast dongle
to enable you to stream wirelessly from your smartphone or tablet
Connecting an AV Source
Follow the picture below to connect a device with an AV cable.
1. Turn off the unit before connecting the AV cable.
2.
Use the AV cable to connect a device as shown in the image below.
3.
After connecting, press the
indicator will light up GREEN
4. Press the
device will show on the projector screen.
/SOURCE button to go to HDMI mode and the video of the
button to turn off the unit power.
button to turn on the projector and the power
/SOURCE button to go to the AV mode and the video of AV
15