Chicago Pneumatic CP 0112 Manuel D'instructions page 16

Safety and operating instructions
Start and stop
Model Start
CP 0112
CP 0112 S
CP 0112 EX
Start the machine by sqeezing the start and stop
♦
device while firmly holding the handle.
Stop the machine by releasing the trigger. The
♦
start and stop device returns automatically to the
stop position.
Operating
Starting a cut
Stand in a stable position with your feet well away
♦
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
16
Stop
www.CrowderSupply.com • Toll Free: 888-883-5144
CP 0112, CP 0112 S, CP 0112 EX
♦ Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool
does not get stuck.
Breaking
Let the machine do the work; do not press too
♦
hard.
Avoid working in extremely hard materials for
♦
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
♦ Any form of idling, operating without insertion
tool or operating with an uplifted machine must
be avoided.
When the machine is lifted, the start and stop
♦
device must not be activated.
Check regularly that the machine is well
♦
lubricated.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
Maintenance
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
9800 0798 90a | Original instructions