Télécharger Imprimer la page

ETNA KCV3143WIT Mode D'emploi page 54

Masquer les pouces Voir aussi pour KCV3143WIT:

Publicité

Les langues disponibles

Les langues disponibles

FAULTS
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
The appliance emits a slight
odour.
The appliance does not
operate; the lighting does not
go on.
Temperature inside appliance
too high or too low.
Water runs from the
refrigerator.
Appliance makes a noise.
The LED lighting does not
work.
Ice building up.
EN 26
Possible cause
New appliance.
Plug not in socket.
Thermostat off.
Thermostat setting incorrect.
The door seals are dirty or
damaged.
Defrost water drain clogged.
Incorrect positioning of food
in the freezer.
There is an object against the
appliance.
LED lighting defective.
Freezer compartment door not
closed properly.
Freezer compartment is not
periodically defrosted.
The door seals are dirty or the
seals are damaged.
Solution
This is normal and disappears
when the appliance starts
cooling.
Insert the plug in the socket.
Adjust the thermostat to the
correct setting.
Adjust the thermostat
properly.
Clean the door seals.
Call the service centre if the
door seals are damaged.
Clean defrost water drain (see
'Defrosting').
Place foods in the proper
manner in the freezer.
Remove the object.
Call an authorized service
technician. Do not attempt
to replace the LED lighting
yourself.
Make sure that the door is
closed properly.
Defrost the freezer
compartment to remove the
ice.
Clean the door seals. Call
the service centre if the door
seals are damaged.

Publicité

loading

Ce manuel est également adapté pour:

Kcv3143wit/e01Kcv3161rvs