Inventum IPF800R Manuel D'utilisation page 14

• Do not allow high flames to develop under the extractor hood.
Do not flambé under extractor hoods. Both can lead to a fire
hazard and cause considerable consequential damage.
• Potential small black spherical particles in the packaging may
have originated from the high-performance carbon filter and
released during transport. These particles are harmless and
can be disposed of with domestic waste. Do not use these
particles for consumption. The functionality of the filter will not
be affected.
3 Description
INTENDED USE
The filter is intended to be used for filtering the air.
Do not use the filter for any other purpose than described in this document.
PLASMA FILTER
(Figure 1)
A Plasma filter
B Hose clamp
C O-ring
4 Installation
INSTALLING THE FILTER
Note:
The filter is installed directly on the motor of the extractor hood.
Preparing the extractor hood
1. Disconnect the extractor hood from the mains supply.
2. Remove the shaft (A) of the extractor hood (extraction) or remove the carbon filter (recirculation).
3. Remove the exhaust hose (B).
Caution:
Make sure that you cover the exhaust opening (A), if present.
Installing the filter
1. Put the O-ring (A) on the extractor hood.
Warning:
Only install the adapter when the motor of the extractor hood is too close to the wall.
2. If necessary, put the adapter (B) and the O-ring (A) on the extractor hood.
3. Put the hose clamp (B) and the filter (A) on the extractor hood or the adapter.
4. Tighten the hose clamp.
14 •
EN
D Adapter
E Mains adapter
(Figure 2)
(Figure 3)
(Figure 4)
(Figure 5)
(Figure 6)