Globestock SAVER GSE414G Instructions D'utilisation page 9

!
6.2. Attaching to the User
• The SAVER can only be used in conjunction with a full-body harness which conforms to all national standards
and regulations applicable.
• The SAVER can only be used with full-body harnesses which conform to;
i.
ii.
iii.
• The SAVER must only be connected to the D-ring on the front or back of the full-body harness.
• Connect the SAVER's snap hook directly to the fall arrest attachment point of the full-body harness. Ensure the
snap hook gate is closed and locked.
!
6.3. Rescuing the User After a Fall
In the event of a fall, the user will remain suspended until raised or lowered to safety. The lowering function is only
intended to a lower a person over a maximum distance of 2 metres. Follow the instructions below to rescue the user.
Models: GSE414G, GSE410SSK & GSE414P
i. Pull out and hold the Retrieval Mechanism Locking Trigger.
ii. Push the Crank Arm towards the SAVER housing to engage the retrieval mechanism. The Crank Arm can be
rotated slightly to assist engagement.
iii. Release the Retrieval Mechanism Locking Trigger.
iv. Rotate the Crank Arm 180° anti-clockwise to disengage the brake mechanism.
v. Raise or lower the user by rotating the crank arm in the appropriate direction. The user will be held by an
internal brake if the operator releases the crank arm during rescue.
1
Do not allow the lifeline to freely retract into the unit while it is in fall arrest mode.
Always leave the SAVER in fall arrest mode when it is not being used.
IMPROPER USE MAY RESULT IN SERIOUS INJURY OR DEATH.
EN 361; or
ANSI/ASSP Z359.11; or
CSA Z259.10
Do not rely on feel or sound to verify proper snaphook engagement. Always visually check
for proper engagement.
IMPROPER USE MAY RESULT IN SERIOUS INJURY OR DEATH.
2
WARNING
WARNING
3
9
4 4
EN