4.3. Anchorage Connectors
•
Any anchorage connectors (e.g. karabiners) used to connect the SAVER to any anchorage must conform to all
national standards and regulations applicable.
•
The SAVER can be used in conjunction with anchorage connectors which conform to any of the following
standards;
EN362 or ANSI/ASSP Z359 or CSA Z259
!
5. Pre-Use Inspection
!
5.1. Visual Inspection
i.
Inspect and confirm that the visual load indicator has not been activated. Remove the SAVER from service
immediately if the load indicator is deployed.
ii.
Inspect and confirm the gate locking function of the snap hook.
iii.
Inspect and confirm that all product labels are present and legible.
iv.
Inspect the SAVER for structural damage and corrosion. Verify that the housing attachments are tight; that
there are no missing or altered parts; that there are no cracks, deformations, or deep cuts in the housing or
snap hook.
v.
Inspect and confirm formal inspection record.
vi.
Inspect the ferrules and thimble at the snap hook and confirm there is no evidence of cracks, distortion,
corrosion, or wear in the lifeline.
vii.
Inspect the entire length of the lifeline and confirm there are no kinks, bends, bird caging, changes in diameter,
corrosion, or broken wires.
!
Only anchorage connectors which conform to EN 362 or ANSI/ASSP Z359 or CSA Z259 can
be used with this product.
IMPROPER USE MAY RESULT IN SERIOUS INJURY OR DEATH.
Inspect the SAVER before every use according to the criteria below.
Remove the SAVER from service and quarantine immediately if it fails any of the pre-use
inspections.
Consult the manufacturer or a competent person if you have any doubts about any of the
inspection criteria.
IMPROPER USE MAY RESULT IN SERIOUS INJURY OR DEATH.
Always maintain tension whilst extracting the lifeline on the lifeline whilst extracting.
Do not let go of lifeline, allowing it to retract freely into the case.
IMPROPER USE MAY RESULT IN SERIOUS INJURY OR DEATH.
WARNING
WARNING
WARNING
7
EN
EN