Publicité
Les langues disponibles
Les langues disponibles
FR
FR
7. TROUBLE SHOOTING
ES
ES
PT
PT
Problems
IT
IT
EL
EL
Device doesn't
start.
PL
PL
RU
RU
Device operates
KZ
UA
sporadically or
at low power.
UA
KZ
RO
RO
Wood burns at
BR
BR
ends when cut.
EN
EN
Material frays or
chips out.
372
Probable causes
The battery is less
Check the battery and charge it.
power.
The charger is
broken.
Repair by customer care.
On/off switch may
be defective.
Engine faulty.
The battery is less
Check the battery and charge it.
power.
Worn or cracked
Check Carbon Brushes.
Carbon Brushes.
Replace if damaged or worn.
Clean Blade using blade cleaner or mineral spirits.
Dirty Blade.
Check position of work material on Table. Material must
Material is
be flat, flush against
binding.
Fence and supported on ends.
Finished side is
Keep finished side of material up or facing operator.
down.
Bottom and back side are prone to chip out.
Blade chipped or
Check for damaged teeth.
dull.
Sharpen or replace blade.
Check blade manufacturer's recommendations for
Blade
material being cut. For cross cutting hard wood and
inappropriate
for precision cuts use a thin kerf blade with 60 or more
for material.
teeth.
Use a thin piece of scrap material, such as 1/4" plywood,
Material is
underneath or behind the material to support the edges
unsupported.
of the material as it is being cut.
Corrective action
Publicité
