Publicité
Les langues disponibles
Les langues disponibles
5. OPERATION
TO BEVEL CUT
Hold the saw firmly with both hands. Rest the front edge of the base on the workpiece. Start the
saw and let the blade reach full speed. Guide the saw into the workpiece and make the cut. Release
the switch and allow the blade to come to a complete stop. Lift the saw from the workpiece.
POCKET CUTTING
WARNING: Always adjust bevel setting to 0° before making a pocket cut. Attempting a pocket
cut at any other setting can result inloss of control of the saw possibly causing serious injury.
Adjust the bevel setting to 0°.
Set the blade to the correct blade depth setting.
Swing the lower blade guard up using the lower blade guard handle.
NOTE: Always raise the lower blade guard with the handle to avoid serious injury. Hold the lower
blade guard by the handle while keeping your hand on the front handle. Rest the front of the
base flat against the workpiece with the rear of the handle raised so the blade does not touch the
workpiece. Start the saw and let the blade reach full speed. Guide the saw into the workpiece and
make the cut.
WARNING: Always cut in a forward direction when pocket cutting. Cutting in the reverse
direction could cause the saw to climb up on the workpiece and back toward you. Release the
switch and allow the blade to come to acomplete stop. Lift the saw from the workpiece.
LENGTH OF CUT SCALE
The saw is equipped with a length of cut scale on its base. It is parallel with the saw blade and can
be used to measure the distance into the material the blade cuts.
NOTE: Six inches is the maximum length of cut that you can measure. Also, it is accurate only when
the depth of cut is set at full maximum depth.
OPTIONAL EDGE GUIDE FENCE
To assemble edge guide fence:
Remove the battery.
Place edge guide fence through slots in base.
Adjust edge guide fence to the width needed.
Tighten edge guide lock knob securely
To use edge guide fence:
Secure the workpiece to prevent movement.
Position the face of the edge guide fence firmly against the edge of workpiece.
FR
FR
ES
ES
PT
PT
IT
IT
EL
EL
PL
PL
RU
RU
UA
KZ
KZ
UA
RO
RO
BR
BR
EN
EN
369
Publicité
