Celestron StarSense EXPLORER LT 80 AZ Guide D'installation Rapide page 2

11
Place the two holes in the base of the finderscope
over the threaded posts so the finderscope base
sits flush on the telescope tube. Make sure that the
round window on the finderscope is pointed away
from the focuser.
14
To install the diagonal, loosen the setscrews on the
back of the focuser and pull out the small dust cap.
Remove the caps from both sides of the diagonal.
17
To use the Barlow lens, remove your eyepiece from
the telescope, insert the Barlow lens into the star
diagonal and insert your eyepiece into the Barlow
lens. This will double the magnification of whatever
eyepiece you use it with.
Downloading and
Activating the App
Before you take your telescope outside, download
the StarSense Explorer app to your mobile device.
Search for "Celestron StarSense Explorer" in the
Apple App Store or Google Play. The app is large,
so we recommend downloading it while connected
to Wi-Fi.
2 ENGLISH
|
12
Thread the two nuts back onto the threaded posts.
1 5
Insert the smaller tube on the diagonal into the back of
the focuser and secure it by tightening the setscrews.
1 8
To install the StarSense smartphone dock, loosen
the two setscrews on the dock mount on the top
of the telescope tube and slide the dovetail on the
bottom of the dock into the mount. Secure in place
by tightening both screws.
1
Download the app from the
or
before your first observing session .
When prompted, enter the unique unlock code below to
enable telescope control on your device.
Once you have downloaded the app, locate the
orange postcard in your telescope box. Launch the
app. When prompted, enter the activation code
on the postcard to activate the app. Your code will
unlock up to 5 devices.
13
There is a small clear plastic tab inserted between the
battery and the contact. This was included to prevent
the battery from discharging during shipment. Pull
this out to allow your battery to work.
1 6
To install the eyepiece, loosen the setscrews on the
open end of the star diagonal. Insert the silver barrel
on the bottom of the eyepiece into the star diagonal
and secure by tightening the setscrews. Always start
using your low-power eyepiece (25 mm) to help you
find the target you wish to view. You can always
change to your high-power eyepiece (10 mm) later.
1 9
Remove the lens cap from the front of the telescope.
To observe, look through the eyepiece as shown
above. Focus the image by turning the knobs below
the focuser.