Publicité
Les langues disponibles
Les langues disponibles
English
10
Pre-ground coffee is not a setting that is saved as a previous selected strength setting. Each time you
want to use pre-ground coffee, you need to press the aroma strength icon for 3 seconds.
When you select pre-ground coffee, you cannot select a different aroma strength.
Brewing iced coffee (specific types only)
The coffee is brewed with warm water. Brew over ice cubes for optimal results.
1 Take a glass and fill it halfway with ice cubes.
2 Place the glass under the coffee dispensing spout.
3 Tap the iced coffee icon (Fig. 14).
-
The aroma strength and quantity lights go on.
-
You can now adjust the drink to your preferred taste.
We recommend using aroma strength 3.
4 Press the start/stop
5 To stop dispensing coffee before the machine is finished, press the start/stop
6 For a special iced coffee treat, top it up with cold milk.
Dispensing hot water
1 If attached, remove LatteGo or the milk frother.
2 Tap the hot water icon (Fig. 15).
-
The drink quantity lights go on and show the previous selected drink setting for hot water.
3 Adjust the hot water quantity to your preference by tapping the drink quantity icon (Fig. 3).
4 Press the start/stop
-
The light in the hot water icon flashes and hot water is dispensed from the hot water spout (Fig. 16).
5 To stop dispensing hot water before the machine is finished, press the start/stop
Adjusting machine settings
Adjusting the stand-by time
1 Press the on/off button to switch off the machine.
2 When the machine is switched off: press and hold the Calc / Clean icon (Fig. 17) until the Calc / Clean
light and the Aroma strength lights go on (Fig. 18).
3 Tap the Aroma strength icon to select the required stand-by time: 15, 30, 60 or 180 minutes. Respectively
1, 2, 3 or 4 lights of the Aroma strength icon light up.
4 When you have finished setting the stand-by time, press the start/stop button. The machine switches off.
5 Press the on/off button to switch on the machine again.
Programming the highest default setting of your drinks
The machine has 3 default settings for each drink: low, medium, high. You can only adjust the quantity of
the highest setting. The new quantity can be stored as soon as the start light starts to pulse.
Before you start programming the quantity of a milk drink, assemble LatteGo and pour milk in it.
button.
button.
button again.
button again.
Publicité
