Télécharger Imprimer la page

Perel SMART1310 Mode D'emploi page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
5.
Assembly
Fit the included feet to the unit before using the
appliance. These are to be attached to the base of the
heater using the four included self-tapping screws, taking
care to ensure that they are located correctly in the
bottom ends of the side mouldings.
6.
Overview
Refer to the illustrations on page 2 of this manual.
Heater
1
2
3
Control Panel
1
2
3
4
5
6
7
8
Remote Control
1
2
3
4
7.
Use
Powering the Appliance
Connect the appliance to the mains and switch it on. The current ambient temperature is
displayed.
Select the heating mode (750 W/1250 W/2000 W + frost protection).
Setting the Temperature
Set the desired temperature with the temperature increase/decrease button. The setting
range is 5 °C to 37 °C. The appliance will automatically enter the stand-by mode as soon
as the room temperature reaches the set temperature, and restart heating when the
ambient temperature drops 1 °C below the set temperature.
In frost protection mode, an appliance in stand-by will automatically switch to the highest
heating mode (2000 W) as soon as the room temperature drops to 5 °C and switch off
when the ambient temperature reaches 9 °C.
V. 02 – 22/09/2022
air outlet
control panel
handle
selected heating level
fan
frost protection
selected temperature unit
fan button
temperature increase
temperature decrease
timer button
on-off
Wi-Fi
temperature increase
heat setting
SMART1310
4
5
6
9
10
11
12
13
14
15
16
5
6
7
6
on-off switch
temperature sensor
air inlet
running time
selected temperature
measured temperature
on-off button
IR eye
Wi-Fi button
heat setting button
Wi-Fi LED
fan
temperature decrease
timer
©Velleman Group nv

Publicité

loading