Beta 599DGT Mode D'emploi page 12

ATTENTION:
If an external force is applied to the torque wrench during the power-on/reset or wake up period, an
initial torque offset will be found in the memory.
ACTIVATION DURING SLEEP MODE
– The wrench will auto sleep after about 5 minutes idle for power saving.
Press to wake up the wrench during the sleep mode.
RESETTINGWRENCH
– If the wrench does not function normally, press
LOW BATTERY VOLTAGE PROTECTION
– If the battery voltage is under 2.3 volts, the wrench will display a battery symbol and then turn off
after a while.
SETUP
1 - Power On/Clear
2 - Unit Selection/Setting
3 - Set Torque Value
Use peak hold mode (P) to keep the maximum value achieved while applying torque displayed for a
few seconds.
Pressing (C) will allow the preset value to be restored.
Whereas using track mode (T) will allow the applied torque range to be viewed, without the maximum
applied value being displayed.
To set the chosen mode go to:
STEP 3: PEAK HOLD / TRACK MODE SELECTION
12
together to reset the wrench.


1
2

3