Adler europe AD7716 Mode D'emploi page 6

19. Place the fan heater only on flat, stable surface
20.Always turn the fan heater off and set the thermostat dial to minimum before removin
the power plug from the socket.
21.Never use the fan heater in high humidity rooms – bathroom, shower room, swimming
pools etc. The humidity can cause short circuit, and effect in damaging the device.
22.The operating fan heater needs to be under supervision and in sight all the time. If you
are leaving the room with the fan heater, always turn the fan heater off. If the fan heater is
not used, the power plug has to be removed from the power outlet.
23.Do not connect the fan heater to the automatic switching device, for example
temperature controlling device or time switch.
24.Flammable materials, for example furniture, bedclothes, paper, clothes, curtains should
be kept at least one meter from the fan heater.
25.Do not cover the device or put any objects on it while it is operating. Do not use the
device to dry clothes.
26.The power cord should not be placed above the fan heater, and it should not touch or
be placed near hot surfaces of the fan heater. Do not place the fan heater directly under
the power outlet.
27.The heating surfaces can heat to a temperature of 60 °C or higher. The fan heater
should be in a place that children and animals do not have access to.
28.The device is not intended to be installed or used in vehicles.
29.Some parts inside the device can be hot or cause sparking. Do not use the fan heater in
places, where gasoline, paints or other flammable materials are used or stored.
DESCRIPTION OF THE DEVICE
1. Thermostat dial
2. Power switch/heating power selector
(a) – cold airflow
(b) – 1000W
(c) – 2000W
USING THE DEVICE
The fan heater has two levels of heating power.
Position 0 – device is switched off
Position – unheated air flow
Position I – 1000 W warm air flow
Position II – 2000 W hot air flow
On both heating levels the temperature can be adjusted using thermostat dial (1).
The device is protected against the overheating by the means of a thermal switch, which can power it off for a while. If this happens,
unplug the device and wait couple of minutes. After a while you can continue to use the device.
CLEANING AND MAINTENANCE
1. Make sure the fan heater is not hot.
2. Before cleaning the device remove the plug from the electrical socket.
3. Keep the air inlet and outlet openings clean. Do not allow dust to collect on the openings.
4. Clean the housing using only dry or moist cloth.
5. Do not immerse the device in water!
TECHNICAL DATA
Voltage: 220-240V ~50/60Hz
Power: 1800-2000W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should
be delivered to the dedicated collecting points due to hazarsous components, which may effect the environment. Do not dispose this appliance in the
common waste bin.
ALLGEMEINE SICHERHEITSVORSCHRIFTEN LESEN SIE AUFMERKSAM WICHTIGE
ANWEISUNGEN BEZÜGLICH DER SICHERHEIT DER BENUTZUNG BEWAHREN SIE
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
geändert.
1.Vor dem ersten Gebrauch, die Bedienungsanleitung lesen und die dort angegebenen
DEUTSCH
DIESE FÜR DIE ZUKUNFT AUF
6
This device is made in class II insulation and does not require grounding.
The device is compliant with the requirements of the following standards:
The Low Voltage Standard (LVD)
Electromagnetic compatibility (EMC)
The product is CE marked on the nameplate