Cutting Procedures - Metabo HPT CM 4SB2 Instructions De Sécurité Et Mode D'emploi

CUTTING PROCEDURES

1. Set the machine body (base) on the
material to be cut; use the side on the base
to align the diamond wheel with the cutting
line. (Fig. 5)
2. Turn the switch ON with the diamond wheel
initially kept off the material to be cut.
The power switch is turned ON when the
trigger is pulled by one's finger while the
stopper is depressed, and is turned OFF
when the trigger is released.
.
CAUTION
●
Do NOT use the diamond wheel for cutting along curves or at angles; otherwise, it
may be damaged, resulting in extremely shortened service life.
●
Before starting to cut, confirm that the diamond wheel has attained full-speed
revolution.
●
Should the diamond wheel stop or make an abnormal noise while operating, promptly
turn OFF the switch.
●
Always take care in preventing the power cord from coming near to the revolving
diamond wheel.
●
When finished with a job, pull out the plug from the power receptacle.
●
Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held
more securely than by hand.
Base
Cutting line
Fig. 5
English
Guide line
on the
base
Guide line
on the base
11