To add a forgotten item:
1. Press Start/Pause to pause the washer.
2. Wait for the door to unlock automatically, and then open the door.
3. Add the item, close the door, and then press Start/Pause. The cycle will resume.
Getting started
1. Load your washer.
2. Add liquid (or powder) detergent and additives to the dispenser (see the "Detergent use"
section on page 42).
3. Select the appropriate cycle and options for the load (see the "Washing a load of laundry"
section page 30).
4. Close the lid.
5. Press Start/Pause.
6. The Wash Indicator illuminates.
7. The estimated cycle time will appear in the display.
The time may fluctuate to indicate the time remaining in the cycle.
NOTE
The actual time required for a cycle may differ from the estimated time in the display
depending on the water pressure, water temperature, detergent, and laundry.
8. Before your washer starts to fill, it will make a series of clicking noises to check the door
lock and do a quick drain.
NOTE
•
When the cycle is complete, the
the display.
•
Pressing Power cancels the cycle and stops your washer.
•
The Wash, Rinse, and Spin indicators will illuminate during those portions of the cycle.
WA7700M_DC68-03774D-01_EN.indd 29
To input a blanket
Fold the blanket into the blanket-specific net
as shown, and then insert in the tub below
the plastic area of the tub.
CAUTION
Make sure the laundry is inserted completely.
•
Any exposed part of the laundry may
cause damage to the machine or the
laundry itself, or a water leak.
•
Do not overload the tub. Make sure no
part of the laundry is exposed outside of
the tub.
Door Lock indicator will go out and "End" will appear in
English 29
2017-11-28
10:34:43