Specifications - Clarion CC510 Mode D'emploi Et Manuel D'installation

WARNING
• This device has been designed
exclusively for use with a vehicular
mounted rear-view system. It should
not be used for other purposes.
• Disconnect the vehicle's negative (–)
terminal when installing wiring.
• Do not attempt to disassemble or
modify this product.
• In the event it is necessary to drill
holes in the vehicle for mounting,
confirm that the drill bit or camera
wiring will not strike or interfere with
piping, gas tank, electrical wiring or
other functional parts of the vehicle.
• Do not rely solely on the monitor
image when reversing the vehicle.
The rear-view monitor is an auxiliary
device meant for confirming the
presence of obstacles to the rear of
the vehicle, and is limited in its range.
It should be used only in conjunction
with direct visual observations.
• Always reverse at low speeds.
The rear-view monitor produces a wide
angle image, with the result that
actual distances may be different than
they subjectively appear in the monitor.
• Do not use when the imaging surface
or other parts are malfunctioning.
• When installation and wiring are
completed, confirm that the vehicle's
horn, brake and warning lights, and
other electrical equipment function
properly as designed.

3. SPECIFICATIONS

Power source/voltage:
Power consumption:
Image sensor:
Angle of view:
Minimum subject illumination:
Ingress Protection:
SN ratio:
Weight:
Dimensions:
Note: Specifications and design are subject to change without notice
for further improvement.
• Install only as directed in the
Installation Manual.
• Install accessory parts as directed.
• When drilling holes in the vehicle for
installation of wiring, always use
insulated grommets in the holes to
protect the wiring.
• If holes are drilled in the vehicle to
install the camera, or when installing
wiring, use silicon sealant to seal any
gaps.
• Do not damage or scar the camera
wiring.
• After completing the camera wiring,
use cable clamps or insulation tape
to bundle the wiring together.
• The images produced from the rear-
view monitor are inverted right-left
in the same way as images seen
in the vehicle's rearview mirrors. The
image may differ depending on the
vehicle type.
• Do not use high-pressure car
washing devices around the camera.
The camera is a high-precision
instrument and should not be subjected
to high-pressure water stream impacts.
• Periodically check the tightness of
the installation screws and retighten
if necessary.
DC 12.0V (10.8 ~ 15.6V)
Max: 100mA (±20mA)
1/4" Color CMOS sensor
150 degrees (horizontal), 90 degrees (vertical)
0.5 lux (at 50 IRE)
IP67
36 dB (AGC ON) or better
0.423 ounces (0.0265 pounds)
23 (W) x 23 (H) x 22 (D) mm
CAUTION
CC510
3