Kinderkraft RAPID Guide D'utilisation page 10

Attention:
● Compliance with the user manual ensures safe use of the toy. Read the user manual carefully before using the
bike and keep it for future use. Recommended age: 3+.
● Use personal protective equipment such as helmets, gloves, elbow pads and knee pads. This product is intended
for outdoor use. Do not use in road traffic. The kids cruiser bike should not be used near motor vehicles, streets,
swimming pools, hills, roads, stairs or on uneven ground.
● Use the toy on flat, obstacle-free surfaces.
● To avoid serious injuries, continuous adult supervision is necessary.
● To avoid falls and collisions causing injury to the user or others, parents/guardians should draw children's
attention to the safety precautions to be taken. Before using the product, it is important to explain to children
how to use it safely.
● The person using the product must always wear shoes.
● Assembly must always be carried out by an adult. Before each use, check that the item is not damaged or worn
and that all assembly and fastening parts are in good condition. Ensure that the bolts and nuts retain their auto-
locking properties. Check that the assembly is complete and in good condition. If you notice that some parts are
missing or damaged, do not use the product, but contact your retailer.
● Be careful when riding bicycles, you should know how to ride to avoid falls or collisions that could cause injury
to the user or a third person.
● The safest areas for the persons using the bicycle are those with little or no vehicular traffic, such as private
areas, playgrounds, schoolyards, and school playgrounds.
● This product is intended for a user with a minimum height of 80 cm and a maximum weight of 35 kg.
● Keep the packaging or dispose of it in accordance with local regulations.
● For the safety of children, do not leave parts of the packaging freely accessible (plastic bags, cardboard boxes,
etc.). Risk of suffocation!
● Warning. Not suitable for children under 36 months. Small parts. Choking hazard!
I Bike components
A Frame with rear wheel and seat
B Front fork
C Front wheel
D Handlebar
E Mounting screw for the front wheel x2
F Washer x2
II Assembly of the bike
Start to assemble the bike from screwing the front fork (B) with the front wheel (C) using screws and washers (E&F)
and mounting keys (K) (Fig. 1). Note: The "drive" mark on the wheel should be set in the right direction. Slide the
obtained element in frame (A). Note the correct installation of handlebar limiter (Fig. 2). Then put the metal ring
(I) and handlebar (D) on the top part of the fork previously loosening screws of the handlebar in order to facilitate
the fitting (Fig. 3). Once the handlebar is slid on the upper part of the fork, tighten the screws again. Note! The
handlebar must be tightened to the maximum. Secure he opening in the handlebar from the top with a screw and
the overlay (G&H) (Fig. 4). Note! Tighten the screw (G) in such a way as to be able to freely move the handlebar
while leaving clearance between the bolt and cap. Remove the screw from the bell (J). Place the bell on the
handlebar and tighten it with a mounting screw. You can adjust the height of the seat using the screw located at
the tube. Remember that the minimum bracket slide mark must be fully hidden in the frame (slide the seat in such
a way so that the arrow on the support is inside the tube) (Fig. 5). NOTE! Before each use check if all the connecting
elements (screw, nuts) are well-adjusted. Small parts must be kept out of the reach of children.
III Maintenance and cleaning, storage
Clean the product with a damp cloth or sponge. Protect from dust, moisture, water, high and very low
temperatures, falls, etc.
G Mounting screw for the front fork x1
H Overlay x1
I Metal ring
J Bell with mounting screw
K Mounting keys x2
10