Publicité
Mounting on a concrete wall
The awnings must be installed at least at the thickness of 10cm only on a
reinforced concrete wall. If the wall shows cracks you have to consult a
professional.
The maximum load for the non-retractable parts of the awning：600N
Tools Recommended:
Chopping bit Ø10mm
HARDWARE:
M6*50
Storage
When it is unused for a long time, it is suggested to take the awning out of the mounting bracket,
and properly store it.
• Before storage, ensure that the tarpaulin is completely dry, so as to prevent mildew and adhesion,
and prevent permanent fatigue of waterproof adhesive tape in bending, and extend the service life
of awning
• Attention! At least Three healthy adults are needed for this step.
• Remove the awning by above step of mounting instructions in reversed order.
• Retract the awning completely.
• Store the awning in a dry and safe place away from children.
Maintenance
Maintenance can extend the service life of the awning.
• Check whether the bolts are loose once a month; please tighten if loose bolts and nuts are found
• If it is damaged or not properly tightened, please immediately stop using the Pergola awning
• Clean once a month to keep the appearance clean
• After cleaning the tarpaulin, check the tightness of the fabric.
• Under normal circumstances, awning does not need lubrication. If there is abnormal noise or hard
contraction, please use plastic lubricant, and do not use petroleum-based lubricant.
• Avoid leaving frozen ice on awning, or it is easy to damage the sunshade cloth and cause
needless loss.
• If problems occur in the process of using, please contact the authorized center for inspection and
maintenance.
Wind resistance class
The awning is rated Wind Class 1 when firmly anchored with the correct mounting material and
must be retracted immediately at wind speeds of 28 km/h and above.
Wind Class 1
Speed 20-28 km/h = 5.5-7.9 m/s.
Disposal:
The same as the installation steps; three adults with professional skills are needed; the disassembly
is opposite to the installation.
At the end of your item's long service life, please dispose of the valuable raw materials properly so
that proper recycling can take place. If you are not sure how best to proceed, the local waste
disposal companies or recycling centre will be happy to help.
Publicité
